Start Cleaning; Pause Cleaning; Sleep; System Resetting - Ezviz Rc3P Bedienungsanleitung

Start Cleaning

Short press the
Recommended start the Full-house Cleaning Mode when the Robot is on the Auto-empty
Base. The Robot will leave the Auto-empty Base and clean in Zigzagging way, and then clean
the area along the wall.
• If the battery level is too low to start cleaning, please charge it first.
• Before cleaning, all wires on the ground should be well organized for fear of power
• Do not move the Auto-empty Base during cleaning, and make sure that the Auto-empty

Pause Cleaning

Pressing
Pressing

Sleep

Automatically switch to Sleep Mode:
• The Robot is inactive and the Auto-empty Base is not connected for 10 minutes.
• There is no operation within 10 minutes after the Robot is fully charged.
Manually switch to Sleep Mode:
Press the

System Resetting

In Standby Mode, press and hold the
After resetting the system, the Robot will lose the original settings and restore to factory settings.
button to start the Full-house Cleaning Mode.
interruption or damage to articles caused by pulling the power cord during cleaning.
Base is powered on, otherwise the Robot may not be able to return for charging.
will pause the Robot while cleaning.
will stop the Robot while cleaning.
button on remote control.
and button for 15s to reset the system.
15