Ezviz RC3P Bedienungsanleitung Seite 12

Please ensure that the Robot will response with a beep after you operate the remote control.
Name Description
Press
*
Under the Sleep Mode, the Robot will enter a low energy-comsumption state, you can still use the remote control to
operate it.
Power
Press
* Under the Standby Mode, the Robot will stop the current task.
Press
Sweep At Fixed
around the current Robot location.
Points
* Under this mode, the Robot will vacuum with a increasing radius and then a decreasing radius till back to the original
starting point.
Recharge Press
Press
(clean in Zigzagging way first and then along the wall)
Start/Pause
Press
Press
Suction Regulation
Standard:
Press
select the time you want by pressing
Time Settings
Press
Press
Press
Sweep Along the
Wall
* After along-wall cleaning is finished, the Robot will enter the Recharge Mode automaticaly.
Press
Press
Appointment
Settings
After settings are completed, press
Press and hold
• When controlling the Robot remotely with its Remote Control, stay within the infrared signal range of 7m or the remote
control may fail.
• When the Recharge button is pressed, search may fail due to too complicated surrounding obstacles or the exhaustion of
the Robot's battery.
• As the infrared ray cannot surpass the wall, please operate the remote control within a visible scope.
once when the Robot is standby, it will sleep.
once when the Robot is operating, it will become standby.
to enter Fixed-point Cleaning Mode, it will perform vacuum spirally with a 1.5m in diameter
once, enter Recharge Mode.
once in Standby Mode, enter the Auto-vacuum Mode.
once in any clean mode, enter the Standby Mode.
to adjust the suction regulation.
Max:
when the Robot is powered on, the time on the display screen will blink, and then you can
or to switch the time for minute adjustment.
or to save your settings.
once, enter the Along-wall Clean Mode, the Robot will clean along the wall.
with the Robot on,
for hour adjustment.
or to switch the time for minute adjustment.
to cancel the appointment settings.
.
icon and the time on the display screen will blink, and you can press
or to save it.
11