Quick Start Guide; Preparation; Connect The Power Supply To The Auto-Empty Base - Ezviz Rc3P Bedienungsanleitung

Quick Start Guide

Preparation

Try to avoid using in the environment with stairs (if must, please set up a guardrail), and try to
remove the obstacles on the ground before use.

Connect the Power Supply to the Auto-empty Base

Install the Auto-empty Base in a location that the Robot can easily access. It is recommended
to place the Auto-empty Base against a wall, and on a hard-level surface rather than on rugs or
carpets.
·In order to avoid external heat damage to the Auto-empty Base, please do not place it
next to radiators, heaters, fireplaces, etc.
·For a normal charging process, please do not place the Charging Base in
environments subjected to direct sunlight, rain,snow or humidity.
>0.5m(1.64')
>0.5m(1.64')
No obstacles 1.5m(4.92') ahead
No obstacles 1.5m(4.92') ahead
12
>0.5m(1.64')
>0.5m(1.64')