Bayrol Salt Relax NXT 3 Bedienungsanleitung Seite 25

Safety instructions
13
Hazards from non-compliance with safety information
Non-compliance with safety information can result in
hazards to persons, the environment, and the equipment.
Non-compliance with safety information will result in a
forfeit of any potential right to damage compensation.
Professional installation
This product must be installed by a competent swimming
pool professional. All applicable installation rules and local
regulations must also be observed.
This product is intended for use in private swimming pools
only.
Disconnect power supply (unexpected start)
The controller starts operation as soon as there is voltage
on the incoming power line.
Potential consequence: Damage of property or injury
to persons
– Do not supply the controller with power until all prepara-
tions for a safe start and safe operation have been
completed.
– Before starting any kind of servicing the controller
must be disconnected from power supply network and
secured against reconnection.
Potential overdosing of chlorine
The device only produces chlorine, with no sensor to
measure the value in the pool. Overdosing may occur if the
production rate is not set properly and regular water quality
checks are done.
Potential consequence: Damage of property or injury
to persons (also danger to life)
– Ensure that the chlorine content in the pool remains in
the recommended value range, by regular water quality
checks and adjust production when necessary.
Opening the casing
Danger of electric shock in case of opening the casing.
Potential consequence: Damage of property or injury to
persons (also danger to life)
– Do not open the casing of the controller. Never open the
casing of the controller when device is connected to
power supply network.
Dangerous system settings
Changing system settings (default values) can be dangerous
under certain circumstances.
Potential consequence: Damage of property or injury
to persons
1100040C-4M1201_Salt Relax NXT_Manual.indd 25 1100040C-4M1201_Salt Relax NXT_Manual.indd 25
– Settings must be changed by trained technicians only.
– The operator assumes liability if settings are used
improperly or modified.
Unauthorised access
Unauthorised access may result in dangerous settings.
Potential consequence: Damage of property or injury
to persons
– Make sure unauthorised access to the controller and
accessories such as buffer and cleaning solutions is not
possible at any time.
– In particular, exclude access to the appliance and
accessories by children.
Disregard of mandatory change of components
Not changing relevant components may cause malfunction.
Potential consequence: Damage of property or injury
to persons (also danger to life)
– Change all in the maintenance plan named components
in the specified intervals.
– Check the components for proper condition and function
at the intervals specified in the maintenance plan.
IMPORTANT!
The operator of the plant must ensure compliance with
the relevant accident prevention regulations, other legal
provisions and the generally accepted rules of safety
engineering!
25
03.02.25 17:31 03.02.25 17:31