Bayrol Salt Relax NXT 3 Bedienungsanleitung Seite 23

Winterizing
8
When the measured temperature drops below 15°C, your Salt Relax
chlorine production is stopped. In colder conditions it is recommended to take the Salt Relax
The following procedures guide you to do so when either actively winterize your pool with a running filtration system or
passively winterize your pool system by also taking the filtration system out of operation.
For active winterising (filtration system of the pool
remains running)
– Stop the filter pump.
– Close and empty the bypass containing the production
cell.
In case the electrolysis cell is installed without by-pass,
make sure frost cannot occurs in the technical plant or the cell
can be destroyed!
Maintenance
9
The indicated amount of maintenance is just the minimum
requirement. The frequency of maintenance depends on
the intensity of use.
The frequency of maintenance is determined by the appli-
cable, country-specific requirements! This may result in
considerably shorter maintenance intervals; the relevant
country-specific specifications and standards must be
observed.
Cell cleaning
The Salt Relax is equipped with an adjustable auto-
NXT
matic cell cleaning function. This function is based on the
cyclic switching of the polarity of the chlorine generation
cell and removes possible scale deposits on the cell
sheets with each switching.
If you notice that your chlorine production cell tends to
calcify, you can shorten the polarity cycles.
If you notice that your chlorine production cell remains
perfectly clean even after prolonged operation, you may
increase the polarity cycles. This may have a positive
effect on the life of the chlorine production cell.
1100040C-4M1201_Salt Relax NXT_Manual.indd 23 1100040C-4M1201_Salt Relax NXT_Manual.indd 23
automatically switches to Winter mode and the
NXT
For passive winterising (filtration system of the pool is
shut off)
– Stop the filter pump.
– Close and empty the filtration system. Make sure to drain
the entire circulation system of the pool as much as
possible.
– Close and empty the bypass containing the production
cell.
Please note
The consistent use of Calcinex
the cell!
If, however, heavy limescale deposits have formed on the
cell sheets, you may manually clean the cell. To do this,
remove the cell from the cell holder (be sure to close the
taps of the bypass beforehand. Caution, water may leak-
out) and treat it with BAYROL Cell Renov. Follow the
instructions on the product label.
ATTENTION
Never try to remove the scale mechanically (e.g. with a brush
or metallic objects)! This will irreparably damage the cell.
A mechanically cleaned cell is excluded from the from the
warranty.
system out of operation.
NXT
can extend the lifetime of
®
23
03.02.25 17:31 03.02.25 17:31