Cleaning And Maintenance; Technical Data - ECG TK 2030 T Bedienungsanleitung

Any handling of the device can be done only when it is turned off using the main switch and unplugged from
the outlet.
Turning off the convector
First, set the thermostat control to position „MIN" and switch to position "0". Then always unplug the power
cable from the outlet!
The device shall only be handled when turned off via the switches and disconnected from the network outlet.
Protection against overheating
The internal thermal fuse protects the heater from overheating and automatically shuts down. In this case the
operating indicator light turns off.
If the device shuts itself, unplug the power cable from the outlet. If it cools (in about 15 minutes), the device is
again ready for use. Plug the power cable back into the socket.
If the situation repeats itself, check first, if the thermostat control is properly set and if the ventilation openings
of the device are not covered.
GB

CLEANING AND MAINTENANCE

Always unplug the power cable from the outlet and wait until the device entirely cools. Clean the outer surface
of the convector with a damp cloth. Do not use for cleaning sharp objects or abrasive cleaners, you could
damage the surface of the convector.
You can store the convector only after you properly turn off the main switch, disconnect it from the electrical
outlet and let it cool completely.
CONVECTOR STORAGE
If you do not plan to use the appliance for a longer period of time, it should be placed in a clean and dry
location protected against dust.

TECHNICAL DATA

Max. input power 2000 W
2 power levels: 1200 W a 2000 W
Built-in fan
Continuous thermostat regulation
Safety cut out switch
Free-standing
Nominal voltage: 220–240 V~ 50 Hz
Nominal input power: 1800-2000 W
38