Keeping Pharmaceutical Products, Glass Bottles Or Flasks In The Display Case Is Strictly; Cleaning The Cabinet - Costan Opera Std Betriebsanleitung Für Betreiber

• do not lay weights or obstruct the roof of LF versions (see page 6- fig 12).
LIGHTING
Cabinet lights are controlled by a switch located under the case's canopy (see fig. 1, 2 and 3).
For the replacement of the fluorescent light, which is too under the canopy, proceed as follows:
• turn the appliance off using the wall cutoff switch;
• rotate the lamp, plastic shield included, by 90° until a slight "click" is heard and then remove it;
• remove the head pieces and slip the plastic shield off; then assemble the shield and head pieces on the new lamp
(see fig. 23, page 7);
• following the above procedure in the reverse order, install the new lamp and make sure that it works correctly.
SHELVES
For a better or different product layout, the shelves may be inclined downwards by 12°. They can be reclined by sim-
ply changing their hooking position on the rear uprights (fig. 18 - page 6).
2
Shelves were designed for a maximum load of 165 kg/m .
9. PRESCRIPTIONS AND RESTRICTIONS

KEEPING PHARMACEUTICAL PRODUCTS, GLASS BOTTLES OR FLASKS IN THE DISPLAY CASE IS STRICTLY

FORBIDDEN as they could get broken and entail a safety hazard (fig. 13).
Except for the front lower fairing panel, which needs being removed to clean the condenser and reach the
evaporation tray, DO NOT REMOVE COVERS OR PANELS WHEN IT REQUIRES THE USE OF TOOLS. MOST
OF ALL, DO NOT REMOVE THE ELECTRIC CONTROL BOARD COVER.
Do not expose the display case to atmospheric agents.
Do not spill water directly or indirectly on the display case (fig. 17). Do not touch the machine with damp or
wet hands or feet; do not use it while barefoot (fig. 16).
ANY OTHER USE NOT EXPLICITLY MENTIONED IN THIS BOOKLET MUST BE CONSIDERED AS HAZARDOUS.
THE MANUFACTURER DISCLAIMS ALL LIABILITY FOR ANY DAMAGE RESULTING FROM IMPROPER, INCOR-
RECT OR UNREASONABLE USE.
10. ORDINARY MAINTENANCE
ATTENTION! BEFORE MAINTENANCE OR CLEANING, DISCONNECT THE REFRIGERATOR FROM THE
POWER SUPPLY USING THE WALL MAIN CUTOFF SWITCH (fig. 18).
IMPORTANT: During maintenance or cleaning operations, be sure that the light in the working area is suffi-
cient. If necessary, use an additional source of light. Mind also the hot and moving parts marked with the
relevant symbol. The use of heavy duty gloves is recommended.

CLEANING THE CABINET

1) Every week clean the outer surfaces of the display case with mild soap or detergent in lukewarm water only.
Wipe carefully with a soft cloth. Never clean it using inflammable or scouring agents, alcohol, acetone or solvents.
NEVER CLEAN THE DISPLAY CASE BY THE USE OF WATER JETS (fig. 17). Clean glass surfaces using glass-
cleaning products only. The use of water is not recommended here, as it may cause scale to build up.
2) Every month clean the cabinet's inside surfaces following the instructions provided in the preceding item and
those indicated herebelow:
INSTRUCTIONS FOR USE- OPERA - cod. UM00090V
english
agine PostS
20
CRISTALLO