LD Systems DQOR SUB 8 Bedienungsanleitung Seite 7

ATTENTION:
1. Do not install or use the device in the vicinity of radiators, accumulators, stoves, or other
heat sources. Ensure that the device is always installed in such a way that it is sufficiently
cooled and cannot overheat.
2. Do not place any ignition sources such as burning candles near the device.
3. Ventilation openings must not be covered, and fans must not be blocked.
4. For transport, use the original packaging or packaging provided by the manufacturer.
5. Avoid any impacts to or shaking of the device.
6. Observe the IP rating and the ambient conditions such as temperature and humidity
according to the specifications.
7. Devices can be continuously further developed. In the event of deviating information on
operating conditions, performance, or other device properties between the user manual
and the device labelling, the information on the device always takes priority.
8. The device is not suitable for tropical climate zones or for operation over 2,000 m above
sea level.
CAUTION:
Connecting signal cables can cause significant interference noise. Make sure that devices
connected to the output are muted while making connections. Otherwise, noise levels may
cause damage.
ATTENTION: HIGH-VOLUME AUDIO PRODUCTS!
This device is designed for professional use. The commercial operation of this device is
subject to the applicable national regulations and guidelines for accident prevention.
Hearing damage due to high volume and continuous exposure: use of this product may
generate high sound pressure levels (SPLs) that may cause hearing damage.
Avoid exposure to high volumes.
INSTRUCTIONS FOR OUTDOOR INSTALLATION EQUIPMENT
1. Devices for installation applications are designed for continuous operation.
2. Equipment for outdoor installation is largely weather-resistant. Depending on the design,
however, seals may be made of materials that deteriorate. These must be checked
regularly and replaced if necessary.
3. The correct condition of the housing parts and connections must be checked regularly.
4. Surfaces and plastic parts can also weather in installation equipment, for example, due to
UV irradiation. This generally does not impair functionality.
5. Damage to the surface coating can impair the device's corrosion protection. Damaged surface
coating (for example, scratches) must be promptly repaired using suitable measures.
6. Screw connections can be impaired in their freedom of movement (for example, due to
oxidation or impurities). Here, appropriate measures for loosening are to be implemented.
7. Unless explicitly stated otherwise on the device or in the technical data, the devices are
intended for installation heights of less than five metres.
7