LD Systems DQOR SUB 8 Bedienungsanleitung Seite 5

This symbol identifies hazards that can cause electric shock.
This symbol indicates hazardous areas or hazardous situations.
This symbol indicates hazards caused by hot surfaces.
This symbol indicates hazards due to high volume levels.
This symbol indicates hazards due to suspended loads.
This symbol indicates a device in which there are no user-serviceable parts.
This symbol indicates additional information on the operation of the product.
SAFETY INSTRUCTIONS
DANGER:
1. Do not open the device, and do not make any modifications to it.
2. If your device no longer functions properly, if liquids or objects get inside it, or if it has
been damaged in any other way, switch it off immediately and disconnect it from the
power supply. This device may be repaired only by authorised repair technicians.
3. For devices of protection class 1, the protective conductor must be connected correctly.
Never disconnect the protective conductor. Devices of protection class 2 do not have a
protective conductor.
4. Ensure that live cables are not kinked or otherwise mechanically damaged.
5. Never bypass the device fuse.
WARNING:
1. The device may not be operated if it shows obvious signs of damage.
2. The device may only be installed in a voltage-free state.
3. If the mains cable of the device is damaged, the device must not be used.
4. Permanently attached mains cables may only be replaced by a qualified person.
5