ATTENTION:
1. Do not operate the device if it has been exposed to large temperature fluctuations
(for example, after transport). Moisture and condensation can damage the device.
Switch on the device only when it has reached ambient temperature.
2. Make sure that the voltage and frequency of the mains correspond to the values specified
on the device. If the device has a voltage selector switch, do not turn the device on until it
has been set correctly. Use only suitable mains cables.
3. To disconnect the device from the mains on all poles, it is not sufficient to press the on/
off switch on the device.
4. Make sure that the fuse used corresponds to the type printed on the device.
5. Ensure that suitable measures have been taken against overvoltage (for example,
lightning strikes).
6. Observe the specified maximum output current on devices with a Power Out connection.
Ensure that the total current consumption of all connected devices does not exceed the
specified value.
7. Replace plug-in mains cables with original cables only.
DANGER:
1. Danger of suffocation/choking! Plastic bags and small parts must be kept out of reach of
persons (including children) with reduced physical, sensory, or mental capabilities.
2. Danger caused by falling device! Make sure that the device is securely installed and
cannot fall down. Only use suitable stands or mounts (particularly for fixed installations).
Ensure that accessories are properly installed and secured. Ensure that all applicable
safety regulations are observed.
WARNING:
1. Use the device in the prescribed manner only.
2. Operate the device only with the accessories recommended and intended by
the manufacturer.
3. Observe safety regulations applicable in your country during installation.
4. After connecting the device, ensure that all cables are routed so as to avoid damage or
accidents, such as from tripping.
5. Always observe the specified minimum distance to normally flammable materials!
Unless explicitly stated, the minimum distance is 0.3 m.
CAUTION:
1. Moving components such as mounting brackets pose a jamming hazard.
6