Huffy 360 Battery Ride-on Bedienungsanleitung Seite 9

Installing Drive Wheels
C
B
STEPS:
NOTE: BEFORE STARTING, CUT PLASTIC TIES AT EACH MOTOR.
1. Insert Motor Ends so wires and Motor are inside Body Holes
2. With one end of Axle
center Lock Button
3. Slide this Wheel/Axle assembly through one Drive Motor
making sure Wheel Gears
4. Install other Drive Wheel
SNAPS into locked position.
WARNING
NOTE:
To remove Wheels, press Center Button
F
C
on ground, insert one Drive Wheel
D
until Wheel SNAPS into locked position.
F
fully seat in Drive Motor Sprockets.
B
fully onto axle and push center Lock Button
: Check that wheels are fully snapped in place by gently pulling outward.
C
E
A
A
B
E
, body and other Drive Motor
D
while pulling Wheel OUTWARDS.
D
B
F
and Axle holes line up.
fully onto Axle and push
D
until Wheel
9