Huffy 360 Battery Ride-on Bedienungsanleitung Seite 20

Radio Frequency Information (if applicable)
CAUTION:
party responsible for compliance could void the user's authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause
undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Torque Table
Recommended Torque:
Use of a torque wrench is recommended. Recommended torque for each fastener is listed below.
In addition to tightening to the recommended torque, please ensure the parts of the product are
sufficiently tightened by performing the functional tests (in the component assembly sections of
the owner's manual) on each component as it is tightened.
NOTE: Please check that all fasteners on the product are torqued according to the table below:
Recommended Torque for clean, dry threads:
Fastener Size
M4 mm (.157 in)
M5 mm (.196 in)
M6 mm (.236 in)
M7 mm (.275 in)
M8 mm (.314 in)
M10 mm (.393 in)
20
Changes or modifications to this unit not expressly approved by the
Torque (N•m / ft-lb)
4.2 N•m (3.1 ft-lb)
6.8 N•m (5 ft-lb)
9.5 N•m (7 ft-lb)
16.3 N•m (12 ft-lbs)
23 N•m (17 ft-lbs)
44.7 N•m (33 ft-lbs)
How to Measure:
Screw or bolt size is determined by
the width at the THREADS as shown.