Function Check; Before Using The Appliance For The First Time - K-Line Kcf 0107 Bedienungsanleitung

Mounting control knobs and the company label
Before carrying out a function check of the appliance the control knobs
and the company label must be mounted. The position of the knobs
can be found in the manual included in the set of control knobs.
=
Attention: Before mounting the control knobs check whether the
axle seals are correctly in place!
In case a mistake was made when mounting the knobs they can be
pulled off again (see chapter Removing control knobs)
Removing control knobs
Please read this text in full and only then try to pull off the control
knobs!
Insert a slotted screwdriver behind the control knob and grip the knob
with one hand.
At the same time:
- lever off the control knob with the screwdriver and
- offset the side force on the control knob (press against it).
As the screwdriver is a lever with a large action, you have to press
harder against the control knob.
When the distance between the control knob and the appliance is
sufficient:
Push your fingers behind the control knob on two sides and pull it off.

Function check

Start up the frying zones individually. The green pilot light must come
on.
Set the temperature regulator to 50 °C. The yellow pilot light (heating
up) must come on. When the set temperature has been reached, the
yellow pilot light goes off.

Before using the appliance for the first time

Clean the appliance before using it for the first time. See operating
instructions.
24