Fitting Your Child In The Stokke® Izi Sleep™ By Besafe - Stokke iZi Sleep Bedienungsanleitung

98
Fitting your child
in the Stokke® iZi Sleep™ by BeSafe®
21
22
3
4
5
Position of harness (3)
Too high
Adjusting the harness (3):
Open the storage compartment (22)
on the back of the car seat. Detach
the harness adjuster (21), and place
it in the correct position by support-
ing the strap from the inside. Make
sure adjuster is clicked in.
Lay the harness (3) over the sides of
the Stokke® iZi Sleep™ by BeSafe®,
before your child is seated.
Put the child in the seat and place
the harness over the shoulder and
close the harness buckle (4). Pull
the central adjuster (5). Make sure
you can fit no more than one finger
between the harness and your baby
(1cm). The harness shall not be
twisted.
When the child weighs over 13kg
or the child's head grows above
the seat, the child shall change to a
group 1 seat.
Too low Correct