Xblitz GO2 Bedienungsanleitung Seite 31

11. FAQ
1. The device does not turn on, the screen flashes.
Charge The device Battery before turning it on.
2. The device does not turn on/ off automatically.
A constant power supply in the cigarette lighter socket can be the reason behind
this.
3. The device restarts while driving.
Check the power source.
4. The device does not record in a loop (records randomly).
Check the "Motion detection" and "Parking Mode" setting - both should
be switched off while driving.
5. The device shows the message "Memory card full".
Check the "G-sensor" and "Parking Mode" functions and set them
to a minimum. The card must
on a computer and then in the recorder.
6. Device records distorted,
The device has a very sensitive microphone, which records all the sounds of the
environment. Recorded sounds can overlap, Windshield air supply also can distort
sound.
7. Device not responding.
Press the RESET button briefly or restore the device to its factory settings.
8. There are lateral stripes In the recording.
Incorrect setting of the image refresh rate value. Set the frequency value to "50Hz"
or "60Hz" depending on your local settings.
Due to continuous product improvement, the manufacturer reserves the right
to change the device and its set without prior notice, some of the functions
described in this manual may be slightly different in reality.
blitz
be formatted in FAT32
unclear sound.
format first
EN