Xblitz GO2 Bedienungsanleitung Seite 25

3. Resolution
The camera can record in several resolutions. The higher the resolution, the better
the quality of the recordings, but also the bigger the file size. It is recommended
to use the highest resolution.
4. C-Sensor
Gravity sensor. When the sensor is switched on, the recording is protected from
being overwritten. It is recommended to set the lowest available value, as a higher
camera can capture shocks caused by uneven roads, which may cause the memory
card to fill up.
S. Parking mode
When it is on,the camera left in the connectedto a powersupply (orwithout
powerbut with a chargedbattery) will senseanyvibrations (for example,caused
by a parking crash),turn on and start recording(recordingsare automatically
protected being overwritten). This modeonly works when the camera
is switched off.
6. Optional GPS module
You can attach a GPSmodule to the GPS port of the Xblitz C02 camera. With it,
the camera will record not only the video, but also the speed with which the vehicle
moves and its location on the map. The GPS module must be purchased separately
- it is not part of the Xblitz G02 camera kit.
To connect the DVR to the GPSmodule, put the plug of the GPSmodule cable into
the GPSport on the camera. Receiving the GPS signal may take up to several
minutes. Reception of the satellite signal depends on the vehicle's location and
environmental factors, which may cause delays in signal reception and its sporadic
loss. To view the route taken and the parameters saved by the CPSmodule,
download a program from: www.xblitz.pl in the G02 tab.
7. Audio recording
The camera can also record
8. Illumination with infrared light
The camera has eight IR LEDs to provide additional illumination
conditions, allowing you to record videos even at night.
blitz
audio.
25
EN
in poor lighting