Profoto Pro-B3 Schnellstartanleitung Seite 5

WARNING – Electrical Shock – High Voltage!
Do not attempt to repair this product yourself, as opening or removing screwed
covers may expose you to the risk of electric shock. Equipment must only be
serviced, modified, or repaired by authorized and competent service personnel!
Warning - The terminals marked with the flash symbol are hazardous live. Do not
open or disassemble flashes, generators or lamp heads! Equipment operates with
high voltage. The flashes, generators or lamp heads can contain hazardous live, for
a considerable time, even when powered off and / or the battery has been removed.
Disconnect the battery and wait at least 10 minutes before attempting to replace
flash tube and/or modelling light. The charger mains cable and plug serve as the
disconnect device from mains power. Always disconnect the charger from the
mains outlet by pulling the plug, not the cable. The socket outlet should be in close
proximity to the equipment and should be easily accessible. Never operate the
equipment without a functioning flash tube and / or modelling light.
Warning - Loud Noise.
5
There is a risk for exposure to sudden loud noise. Please use hearing protection and/
or observe a minimum safety distance of 40 cm (16 in.) between the generator and
users/other people present.
Caution!
Possibly hazardous optical radiation emitted from this product. Do not stare
at operating lamp. May be harmful to the eye. Do not trigger a flash towards an
unexpected subject, any person operating heavy equipment, or on anyone
performing any other activities where an unexpected flash could cause injury or
harm. Please note that flashes can be triggered remotely from a long distance.
Caution – Burn Hazard – Hot Parts!
Do not touch hot parts with bare fingers! Modeling lamps and flash tubes may make
certain metal parts, front lenses or glass covers emit strong heat when used! All lamps
may on rare occasions explode and throw out hot particles! Do not point modeling
lamps or flash tubes too close to persons.
Note about RF!
This equipment makes use of the radio spectrum and emits radio frequency
energy. Make sure the device is operated according to the local regulations. The
frequency spectrum this device is using is shared with other users. Interference
cannot be ruled out. Regulations change from time to time, so please make sure
you are using the latest firmware and instructions to ensure compliance with rules
and regulations The firmware can be updated using Profoto app. According to RF
exposure regulations, under normal operations the end user shall refrain from being
closer than 20 cm from the device.
www.profoto.com