English - Profoto Pro-B3 Schnellstartanleitung

English

IMPORTANT SAFETY INFORMATION & WARNINGS!
Do not operate the equipment before studying the Quick Start and Safety Guide
and the User Guide for both the LST and the lamp heads. Make sure that the Quick
Start and Safety Guide is always accessible to the user! Profoto products are
intended for indoor condition use! Do not place or use the equipment where it can
be exposed to moisture, extreme electromagnetic fields or in areas with flammable
gases or dust! Do not expose the equipment to dripping or splashing. Do not place
any objects filled with liquids, such as vases, on or near the equipment. Should any
water or pollutants such as ash, dust or insects end up in the product, do not touch
the equipment. Contact Profoto service! Do not expose the equipment to hasty
temperature changes in humid conditions as this could lead to condensation water
in the unit. Do not modify, disassemble, open, drop, crush, puncture, heat above
60°C (140°F), incinerate, or shred battery. Keep batteries (battery pack or battery
4
installed) away from open flame or sunlight to prevent heat build-up. Risk of fires
and burns, rupture and explosion, electrolyte leakage and/or venting. The emissions
are toxic. Provide for good ventilation in case of leakage and/or ventilation. Move
exposed persons to fresh air and seek medical attention. Do not short-circuit the
battery or its cells. In the event of a cell leaking, do not allow the liquid to come in
contact with the skin or eyes. In case of contact with skin or eyes: rinse immediately
with fresh water and seek medical attention. Stop using the battery if it becomes
hot, discolored or deformed. Only use the intended Profoto charger(s) to charge the
battery. Do not connect lights, or use light shaping tools, from other manufacturers.
Always use protective gloves and safety glasses while performing maintenance
on the flash equipment. The front lens shall be changed if it has become visibly
damaged to such an extent that their effectiveness is impaired, for example by
cracks or deep scratches. If the flash product enclosure should crack, immediately
stop using the product and contact Profoto Service! It is unavoidable that the type of
capacitor used in flash products can sometime break. If this should happen a sharp
smell may emit from the flash product along with smoke. Avoid getting the emission
in the face. If the emissions should get in the eyes or mouth, rinse with water. The
emission is nontoxic. Rinse with water and soap if you get leaking electrolyte on
skin. Do not ingest the electrolyte. Always lift generators and lights by their handles
and never by the connectors or cables. Do not connect or charge the battery, or
otherwise operate a product which has been left in a hot or cold environment, such
as a car. Let the product reach the approved operating temperature before doing
so. Do not mount or use the equipment at a height exceeding 2 m (6.5 feet). When
using a stand, always make sure that the equipment is securely attached. Remove
transport cap from lamp head before use! Never install the product in a confined
space. Always leave a space around the product for ventilation, do not cover
any ventilation openings! Do not obstruct ventilation by placing filters, diffusing
materials, etc. over inlets and outlets of the equipment ventilation or directly over
glass cover, modeling lamp or flash tube! Product shall not be exposed to excessive
heat such as sunshine, heat sources, and fire or similar. Profoto products are only
intended for the purpose of image capture, such as photography and videography.
They are not intended for use in any other application.
www.profoto.com