Electrical Connection - Caso WineControl Originalbetriebsanleitung

13.5 Electrical connection

caso WineControl
Take any packaging materials that are no longer required to
"Green Dot" recycling collection points for disposal.
► If possible, keep the original packaging for the device for the
duration of the guarantee period of the device, in order that
the device can be re-packaged properly in the event of a
guarantee claim.
In order to ensure the safe and trouble-free operation of the
device, the following instructions must be observed for the
electrical connection:
• Before connecting the device, compare the connection data
(voltage and frequency) on the rating plate with those of your
electrical network. This data must agree in order that no
damages occur in the device
If in doubt, ask your qualified electrician.
• The electrical outlet must be protected by a 16A safety cut-out
switch.
• The connection between the device and the electrical network
may employ a 3 meter long (max.) extension cable with a cross-
section of 1.5 mm². The use of multiple plugs or gangs is
prohibited because of the danger of fire that is involved with
this.
• Make sure that the power cable is undamaged and has not
been installed under the oven or over hot or sharp surfaces.
• The electrical safety of the device is only guaranteed if the
device is connected to a properly installed protective conductor
system. Operations using an electrical outlet without a
protective conductor are prohibited. If in doubt, have the house
installation checked over by a qualified electrician.
The manufacturer cannot be made responsible for damages
that are caused by a missing or damaged protective conductor.
Please note
Commissioning
28