fors TP 8359 Benutzerhandbuch Seite 19

1)
Problem
Not possible to
change the pro-
gram or option.
Not possible to
select an op-
tion. Acoustic
signal is emit-
ted.
No drum light
Unexpected
duration time
on the display.
Program inac-
tive.
Drying cycle too
short.
Drying cycle too
6)
long
1) If there is an error message on the display (e.g. E51): Turn the tumble dryer off and on. Select a new program.
Push the Start/Pause button. If the appliance does not operate contact the service centre and provide the error
code.
2) Follow the program description — see PROGRAMS chapter
3) See chapter CARE AND CLEANING
4) Only dryers with Dryness (Trockengrad) option
5) See HINTS AND TIPS chapter
6) Note: After a maximum of 5 hours the drying cycle ends automatically.
Possible cause
After cycle start it is not possible to
change the program or option.
The option you tried to select is not
available for the selected program.
Defective drum lamp.
The drying duration is calculated ac-
cording to load size and dampness.
The water container is full.
Load size is small.
The laundry is too dry.
The filter is clogged.
The load is too large.
The laundry was not spun sufficient-
ly.
Too low or too high room tempera-
ture - this is not the appliance mal-
function.
Remedy
Turn the tumble dryer off and on.
Change the program or option as
required.
Turn the tumble dryer off and on.
Change the program or option as
required.
Contact the service centre to re-
place the drum lamp.
This is automated — the appliance
is working correctly.
Drain the water container, push the
Start/Pause button.
Select time program. The time value
must be related to the load. To dry
1 item or a small amount of laundry
we recommend short drying times.
Select time program or higher dry-
ness level (e.g. extra dry (Extra-
trocken))
Clean the filter.
Do not exceed the maximum load
size.
Spin the laundry well.
Ensure a room temperature higher
than +5°C and lower than +35°C.
Optimal room temperature to ach-
ieve best drying results is between
19°-24°C.
19
3)