iStorage DATASHUR SD Benutzerhandbuch Seite 8

1. Press and hold down the SHIFT (
for one second
2. In Standby State (solid
KEY ( ) button once
3. With the GREEN and BLUE
enter the Admin PIN and press the KEY ( ) button
again
Note: Once datAshur SD has been successfully unlocked, the
only, during which time the datAshur SD needs to be connected to a powered USB port. It can be locked down
immediately (if not connected to a USB port) by pressing and holding down the SHIFT (
or by clicking the 'Safely Remove Hardware/Eject' icon within your operating system when connected to a USB
port.
When the datAshur SD is unlocked and connected to a USB port, it will not accept further instructions via the
keypad.
5. To enter Admin Mode
The Admin PIN can be used to setup the datAshur SD with a host of security features including the creation of a secondary
User PIN by first entering the Admin Mode indicated by a solid
Note: The datAshur SD must not be connected to a USB port when accessing Admin Mode.
To Enter Admin Mode, do the following.
1. Press and hold down the SHIFT (
for one second
2. In Standby State (solid
KEY ( ) button once
3. With the GREEN and BLUE
enter the Admin PIN and press the KEY ( ) button
again
4. Press the KEY ( ) button three times
within 2 seconds (KEY ( ) x 3)
When the datAshur SD is in Admin Mode, the
the drive can accept instructions via the keypad allowing it to be configured with a host of security features. If no key event
happens within 30 seconds, the datAshur SD will exit Admin Mode automatically - the solid
RED LED which then fades out to the Idle State (all LEDs off).
6. To exit Admin Mode
To immediately exit Admin Mode (solid
BLUE LED switches to a solid
datAshur SD must first be in the Idle State (all LEDs off) before an Admin/User PIN can be entered.
#8
) button
RED LED) press the
LEDs blinking together,
) button
RED LED) press the
LEDs blinking together,
BLUE LED will remain on and solid for 30 seconds only, during which time
LED), press and hold down the SHIFT (
BLUE
RED LED which then fades out to the Idle State. To access the drive contents (data), the
A solid RED
in Standby State
GREEN and
GREEN and
GREEN LED indicating the drive has been
successfully unlocked as Admin
GREEN LED will remain blinking for 30 seconds
BLUE LED.
A solid RED
in Standby State
GREEN and
GREEN and
several times and then to a solid
changing to a blinking
device is unlocked
Blinking GREEN
LED indicating the device is in Admin Mode
www.istorage-uk.com
LED switches on indicating the drive is
BLUE LEDs blink together
BLUE LEDs change to a blinking
) button for a second
LED switches on indicating the drive is
BLUE LEDs blink together
BLUE LEDs will alternately blink
BLUE LED
GREEN LED indicating the
LED will change to a solid
BLUE LED switches to a solid
) button for a second - the solid
BLUE