iStorage DATASHUR SD Benutzerhandbuch Seite 5

1. LED indicators and their actions
LED LED State
RED Solid
RED - Fade Out
GREEN Blinking
GREEN Solid
BLUE Solid
2. Battery and LED States
Note: The normal function of the datAshur SD may be disturbed by strong Electro-Magnetic Interference. If
so, simply power cycle the product (power off then power on) to resume normal operation. If normal operation
does not resume, please use the product in a different location.
Low Battery Sensor
The datAshur SD incorporates voltage detection circuitry that monitors the battery output when the device is powered on.
When battery output drops to 3.3V or below, the
connect the datAshur SD to a powered USB port and charge for 20-30 minutes. Once recharged, the datAshur SD will resume
normal function.
To wake from Idle State
Idle State is defined as when datAshur SD is not being used and all LEDs are off.
To wake datAshur SD from the Idle State do the following.
Press and hold down the SHIFT (
button for one second or connect the device
to a powered USB port
To enter Idle State
To force datAshur SD to enter Idle State, execute either of the following operations:
• If the device is connected to a USB port, disconnect it.
• If the device is not connected to a USB port, press and hold down the SHIFT (
turns solid RED and fades out to the Idle State (off).
Description
Locked device (in either
Standby or Reset states)
Device Turning off to the
Idle State
Unlocked device as Admin
(not connected to USB port)
Unlocked device as User
(not connected to USB port) or
device in User Mode
Device in Admin Mode
RED LED flashes three times and fades out. At this point, the User should
)
LED LED State
RED, GREEN
BLUE Blinking
GREEN and
Blinking together
RED and
Blinking together
BLUE blinking every
5 seconds
Rapidly Blinking
GREEN
RED LED lights on indicating the device is in Standby State
www.istorage-uk.com
Description
and
Waiting for User PIN entry
BLUE
Waiting for Admin PIN entry
GREEN
Waiting for Recovery PIN entry
Battery starts charging after 30
seconds when device is locked
and connected to a USB port
Data transfer in progress
) button for a second until the LED
#5