iStorage DATASHUR SD Benutzerhandbuch Seite 21

24. How to delete the Self-Destruct PIN
To delete the Self-Destruct PIN, first enter the Admin Mode as described in section 5. Once the drive is in Admin Mode
(solid BLUE LED) proceed with the following steps.
1. In Admin Mode, press and hold down both
SHIFT ( ) + 6 buttons
2. Press and hold down SHIFT (
Note: When the datAshur SD is in Admin Mode, the
during which time the drive can accept instructions via the keypad allowing it to be configured with a host of security
features. If no key event happens within 30 seconds, the datAshur SD will exit Admin Mode automatically - the solid
BLUE LED switches to a solid
To immediately exit Admin Mode (solid
solid BLUE LED switches to a solid
(data), the datAshur SD must first be in the Idle State (all LEDs off) before an Admin/User PIN can be entered.
25. How to unlock with the Self-Destruct PIN
Warning: When the Self-Destruct mechanism is activated, the encryption key, the Admin/User PINs and all
data are deleted and lost forever. Unless you have cloned another datAshur SD as a backup drive,
self-destructing this drive will also render data on other microSD cards that have been encrypted by this drive
as inaccessible and lost forever too. The Self-Destruct PIN becomes the User PIN. No Admin PIN exists
after the Self-Destruct mechanism is activated. The datAshur SD will need to be reset (see 'How to perform a
complete reset' Section 35, on page 28) first in order to configure an Admin PIN with full Admin privileges
including the ability to configure a User PIN.
When used, the self-destruct PIN will delete the encryption key, ALL data, Admin/User PINs and then unlock the
drive. Unless you have cloned another datAshur SD as a backup drive, self-destructing this drive will also render data on
other microSD cards that have been encrypted by this drive as inaccessible and lost forever. Activating this feature will cause
the Self-Destruct PIN to become the New User PIN and the datAshur SD will need to be formatted before any new data
can be added to the drive.
To activate the Self-Destruct mechanism, the drive needs to be in the standby state (solid
following steps.
1. In standby state (solid RED
down both the SHIFT (
2. Enter the Self-Destruct PIN and press the
KEY ( ) button
) + 6 buttons again
RED LED which then fades out to the Idle State (all LEDs off).
BLUE LED), press and hold down the SHIFT (
RED LED which then fades out to the Idle State. To access the drive contents
LED), press and hold
) + KEY ( ) buttons
www.istorage-uk.com
Solid BLUE
LED
Blinking
change to a solid
Self-Destruct PIN was successfully deleted
BLUE LED will remain on and solid for 30 seconds only,
RED LED switches to all LEDs, RED,
BLUE blinking on and off
RED, GREEN
change to a solid
datAshur SD has successfully self-destructed
LED will change to a blinking
RED LED will become solid and then
BLUE LED indicating the
) button for a second - the
RED LED) and then proceed with the
and BLUE blinking LEDs will
GREEN LED indicating the
RED
GREEN &
#21