iStorage DATASHUR SD Benutzerhandbuch Seite 30

39. How to set your datAshur SD to enable KeyWriter cloning
Note: The datAshur SD is set as default to enable KeyWriter cloning.
The datAshur SD can be used in conjunction with the iStorage KeyWriter application to enable cloning of up to 9 devices at
a time. To set the datAshur SD to enable KeyWriter cloning, first enter the Admin Mode as described in section 5. Once the
datAshur SD is in Admin Mode (solid
1. In Admin Mode, press and hold down both
'KEY ( ) + 8' buttons.
2. Enter '11' and press the 'SHIFT (
Note: When the datAshur SD is in Admin Mode, the
during which time the drive can accept instructions via the keypad allowing it to be configured with a host of security
features. If no key event happens within 30 seconds, the datAshur SD will exit Admin Mode automatically - the solid
BLUE LED switches to a solid
To immediately exit Admin Mode (solid
solid BLUE LED switches to a solid
(data), the datAshur SD must first be in the Idle State (all LEDs off) before an Admin/User PIN can be entered.
40. How to disable KeyWriter cloning
To disable KeyWriter cloning, first enter the Admin Mode as described in section 5. Once the datAshur SD is in Admin
Mode (solid BLUE LED) proceed with the following steps.
1. In Admin Mode, press and hold down both
'KEY ( ) + 8' buttons.
2. Enter '44' and press the 'SHIFT (
Note: When the datAshur SD is in Admin Mode, the
during which time the drive can accept instructions via the keypad allowing it to be configured with a host of security
features. If no key event happens within 30 seconds, the datAshur SD will exit Admin Mode automatically - the solid
BLUE LED switches to a solid
To immediately exit Admin Mode (solid
solid BLUE LED switches to a solid
(data), the datAshur SD must first be in the Idle State (all LEDs off) before an Admin/User PIN can be entered.
#30
BLUE LED) proceed with the following steps.
)' button once.
BLUE
RED LED which then fades out to the Idle State (all LEDs off).
BLUE LED), press and hold down the SHIFT (
RED LED which then fades out to the Idle State. To access the drive contents
)' button once.
BLUE
RED LED which then fades out to the Idle State (all LEDs off).
BLUE LED), press and hold down the SHIFT (
RED LED which then fades out to the Idle State. To access the drive contents
www.istorage-uk.com
Solid BLUE LED will change to blinking
and BLUE LEDs
GREEN and BLUE
GREEN LED and then to a solid
indicating the datAshur SD has been set to
enable KeyWriter cloning
LED will remain on and solid for 30 seconds only,
Solid BLUE LED will change to blinking
and BLUE LEDs
GREEN and BLUE
GREEN LED and then to a solid
indicating the KeyWriter cloning feature has
been disabled
LED will remain on and solid for 30 seconds only,
GREEN
LEDs will change to a solid
BLUE LED
) button for a second - the
GREEN
LEDs will change to a solid
BLUE LED
) button for a second - the