To set the Unattended Auto Lock time-out, first enter the Admin Mode as described in section 5. Once the drive is in Admin
Mode (solid
BLUE
LED) proceed with the following steps.
1. In Admin Mode, press and hold down both
KEY ( ) + 5 buttons
2. Enter the amount of time that you would like to set the Auto-Lock time-out feature for, the minimum time that can
be set is 5 minutes and the maximum being 99 minutes (5-99 minutes). For example enter:
05 for 5 minutes (press '0' followed by a '5')
20 for 20 minutes (press '2' followed by a '0')
99 for 99 minutes (press '9' followed by another '9')
3. Press the SHIFT (
) button
Note:
When the datAshur SD is in Admin Mode, the
during which time the drive can accept instructions via the keypad allowing it to be configured with a host of security
features. If no key event happens within 30 seconds, the datAshur SD will exit Admin Mode automatically - the solid
BLUE
LED switches to a solid
To immediately exit Admin Mode (solid
solid
BLUE
LED switches to a solid
(data), the datAshur SD must first be in the Idle State (all LEDs off) before an Admin/User PIN can be entered.
28. Turn off the Unattended Auto-Lock Clock
To turn off the Unattended Auto Lock, first enter the Admin Mode as described in section 5. Once the drive is in Admin
Mode (solid
BLUE
LED) proceed with the following steps.
1. In Admin Mode, press and hold down both
KEY ( ) + 5 buttons
2. Enter 00 and press the SHIFT (
Note:
When the datAshur SD is in Admin Mode, the
during which time the drive can accept instructions via the keypad allowing it to be configured with a host of security
features. If no key event happens within 30 seconds, the datAshur SD will exit Admin Mode automatically - the solid
BLUE
LED switches to a solid
To immediately exit Admin Mode (solid
solid
BLUE
LED switches to a solid
(data), the datAshur SD must first be in the Idle State (all LEDs off) before an Admin/User PIN can be entered.
BLUE
RED
LED which then fades out to the Idle State (all LEDs off).
BLUE
LED), press and hold down the SHIFT (
RED
LED which then fades out to the Idle State. To access the drive contents
) button
BLUE
RED
LED which then fades out to the Idle State (all LEDs off).
BLUE
LED), press and hold down the SHIFT (
RED
LED which then fades out to the Idle State. To access the drive contents
www.istorage-uk.com
Solid
BLUE
LED will change to blinking
and
BLUE
LEDs
Blinking
GREEN
a solid
GREEN
solid
BLUE
LED indicating the Auto-Lock time
out is successfully configured
LED will remain on and solid for 30 seconds only,
Solid
BLUE
LED will change to blinking
and
BLUE
LEDs
Blinking
GREEN
a solid
GREEN
solid
BLUE
LED indicating the Auto-Lock time
out has been successfully disabled
LED will remain on and solid for 30 seconds only,
GREEN
and
BLUE
LEDs will change to
for a second and then finally to a
) button for a second - the
GREEN
and
BLUE
LEDs will change to
for a second and then finally to a
) button for a second - the
#23