iStorage DATASHUR SD Benutzerhandbuch Seite 7

• For "iStorage" press the following buttons:
4 (ghi) 7 (pqrs) 8 (tuv) 6 (mno) 7 (pqrs) 2 (abc) 4 (ghi) 3 (def)
Using this method, long and easy to remember PINs can be configured.
Important microSD Card
datAshur SD drive. If the datAshur SD drive is unlocked and connected to a host computer using a non iStorage
microSD card, all LEDs, RED,
indicating that the microSD card is not compatible with the datAshur SD drive.
To configure an 8-64 digit Admin PIN and unlock the datAshur SD for the first time, please follow the simple steps in the
table below.
Instructions - First Time Use
1. Insert a genuine iStorage microSD card into the
datAshur SD card slot
2. Press and hold down the SHIFT (
for one second
3. Press and hold down both KEY ( ) + 1 buttons
4. Enter New Admin PIN and press the
KEY ( ) button once
5. Re-enter New Admin PIN and press the KEY ( )
button again
Note: Once datAshur SD has been successfully unlocked, the
only, during which time the datAshur SD needs to be connected to a powered USB port and formatted. Please refer
to one of the following formats:
•
Formatting the datAshur SD for Windows - Section 44 on page 33
•
datAshur SD setup for macOS - Section 45 on page 34
• Initialising and formatting datAshur SD in Linux OS - Section 46 on page 36
Locking datAshur SD
To lock the drive, safely eject the datAshur SD from your host operating system and unplug from the USB port. If data is being
written to the drive, unplugging the datAshur SD will result in incomplete data transfer and possible data corruption.
4. Unlocking datAshur SD with the Admin PIN
To unlock the datAshur SD with the Admin PIN, please follow the simple steps in the table below.
Information: Only genuine iStorage microSD Cards are compatible with the
GREEN & BLUE blink on and off twice and will then change to a solid
LED
) button
www.istorage-uk.com
LED State
Solid RED and GREEN LEDs light up indicating the
drive is in the Initial Shipment State
LEDs turn to blinking GREEN
Blinking GREEN and solid BLUE
a GREEN blink then back to Blinking
solid BLUE LEDs
Blinking GREEN and solid BLUE
a solid BLUE LED and finally to a blinking
LED indicating the Admin PIN has been
successfully configured and drive unlocked
GREEN LED will remain blinking for 30 seconds
RED LED,
and solid BLUE
LEDs switch to
GREEN and
LED switches to
GREEN
#7