iStorage DATASHUR SD Benutzerhandbuch Seite 11

Note: When the datAshur SD is in Admin Mode, the
during which time the drive can accept instructions via the keypad allowing it to be configured with a host of security
features. If no key event happens within 30 seconds, the datAshur SD will exit Admin Mode automatically - the solid
BLUE LED switches to a solid
To immediately exit Admin Mode (solid
solid BLUE LED switches to a solid
(data), the datAshur SD must first be in the Idle State (all LEDs off) before an Admin/User PIN can be entered.
9. How to delete the User PIN Policy
To delete the User PIN Policy, first enter the Admin Mode as described in section 5. Once the drive is in Admin Mode
(solid BLUE LED) proceed with the following steps.
1. In Admin Mode, press and hold down both
KEY ( ) + 7 buttons
2. Enter 080 and press SHIFT (
Note: When the datAshur SD is in Admin Mode, the
during which time the drive can accept instructions via the keypad allowing it to be configured with a host of security
features. If no key event happens within 30 seconds, the datAshur SD will exit Admin Mode automatically - the solid
BLUE LED switches to a solid
To immediately exit Admin Mode (solid
solid BLUE LED switches to a solid
(data), the datAshur SD must first be in the Idle State (all LEDs off) before an Admin/User PIN can be entered.
BLUE
RED LED which then fades out to the Idle State (all LEDs off).
BLUE LED), press and hold down the SHIFT (
RED LED which then fades out to the Idle State. To access the drive contents
) button once
BLUE
RED LED which then fades out to the Idle State (all LEDs off).
BLUE LED), press and hold down the SHIFT (
RED LED which then fades out to the Idle State. To access the drive contents
www.istorage-uk.com
LED will remain on and solid for 30 seconds only,
Solid BLUE LED will change to blinking
and BLUE LEDs
Blinking GREEN
a solid GREEN
LED indicating the User PIN Policy has been
successfully deleted
LED will remain on and solid for 30 seconds only,
) button for a second - the
GREEN
and BLUE LEDs will change to
LED and finally to a solid BLUE
) button for a second - the
#11