Werbung
Verfügbare Sprachen
Verfügbare Sprachen
EN
Preparation
• Remove coarse dirt beforehand with
a standard vacuum cleaner.
• If there is a lot of dirt, first spray addi-
tional cleaning agent onto the surface
to be cleaned and spread it around with
a brush if necessary. It is essential to
follow the instructions on the bottle of
the cleaning agent.
• Assemble the nozzle components and
attach them to the handle (see the
" Accessories" chapter).
• Make sure that the fresh water tank (16)
is filled (see the "Filling the Fresh Water
Tank" chapter) and both tanks are
inserted in the motor unit (14).
• Remove the protective cap (1) from the
nozzle.
Operation
1. Fully unwind the connecting cable and
plug the mains plug into a plug socket.
flashes, the device is in standby. Mode
(cold water) is selected.
• To select another mode, touch the
corresponding icon on the control
panel (15):
Cold water and vacuum
Hot water and vacuum
Steam and vacuum
Steam
2. If mode
(steam) has been selected:
Wait a few seconds until the water has
heated up and the
constantly.
3. Touch
to switch the device on.
4. Press the spray button (6) on the handle
and spray / steam onto the surface to be
treated.
16
15078_Inlay_DE-EN_A5_V1.indb 16
15078_Inlay_DE-EN_A5_V1.indb 16
5. Pull the nozzle opening with gentle pres-
6. When the fresh water tank is empty or
L
7. Touch
After Use
1. Empty the fresh water tank and reinsert it.
2. Switch on the device again and press
3. Touch
4. After every use, fully empty and clean
Signal tones and voice output
By default, the signal tones and voice output
are switched on.
• To turn off: Touch
symbol lights up
• To turn on: Touch
sure over the surface to be cleaned. The
dirty water is sucked up and collected in
the dirty water tank (13).
the dirty water tank is full, touch
switch off the device. Only after this
should you fill or empty the appropriate
tank (see the "Cleaning the Device"
chapter).
Place the nozzle on a cloth as resid-
ual water may escape after it has
been switched off.
to switch the device off. In
modes with suction function, this may
continue to run for a few seconds.
the spray button to remove excess water
from the device.
to switch off the device. Then
pull the mains plug out of the plug
socket.
the tanks (see the "Cleaning the Device"
chapter).
and
seconds until you hear "Voice off".
and
seconds until you hear "Voice on".
to
for a few
for a few
21.08.2024 10:45:52
21.08.2024 10:45:52
Werbung
