RUSTA SLIM Gebrauchsanweisung Seite 5

Don´t place
the soda maker in
a sunny window.
USE
OPERATING INSTRUCTIONS:
UNLOAD HEAD
Unload the supporting body of the soda maker, rotate the machine
head to the left, and then remove the machine head.
INSTALL CYLINDER
Take the machine head in your left hand and rotate the cylinder to the
right to screw it into the machine head.
INSTALL MACHINE HEAD
Put the end of the cylinder into the supporting body of the machine
and rotate the machine head to the right to complete the installation.
INSTALL WATER BOTTLE
Fill the water bottle with water so that the water level is between the
"min" and "max" markings. Align the bottle opening and its spikes
with the entrance to the machine head. Rotate it to the right until it is
completely fixed on the machine head.
CARBONATING
Press the carbonating button 2-3 times, holding down the button
1 second each time.
REMOVE WATER BOTTLE
Wait 2-3 seconds while the machine releases the residual pressure.
After hearing the pressure release, remove the water bottle.
Don´t place
the soda maker
close to a
hot radiator.
Don´t place
the soda maker
close to an open
flame.
Don´t place
the soda maker
in extreme
hot conditions.
5