Beatbot iSkim Ultra Bedienungsanleitung Seite 5

1.3 FCC/IC Statement
Any changes or modifications not expressly approved by the part responsible for compliance
could void the user's authority to operate the equipment. This equipment has been tested and
found to comply with the limits for a Class B digital device, under part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful interference in a residen-
tial installation. This equipment generates uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, it may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encour-
aged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment to an outlet on a circuit different from that to which the receiver is con-
nected.
Consult the dealer or an experienced radio/TV technician for help.
1.4 MPE Requirements
To satisfy FCC / IC RF exposure requirements, a separation distance of 20 cm or more
should be maintained between the antenna of this device and persons during device
operation. To ensure compliance, operation closer than this distance is not recommend-
ed.
Under normal use conditions, this equipment should be kept a separation distance of at
least 20cm between the antenna and the body of the user.
1.5 Water Conditions for Robot Use
Water Depth
PH
Chlorine
Salt
≥0.15m/5.9 inches
7.0-7.8
Max 4 PPM
Max 5000 PPM
3
EN