two trees SK1 Bedienungsanleitung Seite 16

12.3 OrcaSlicer configuration import
3.1 Find the OrcaSlicer software installation package in your USB drive (you can also download it from the official website) and
proceed with the installation. Please make sure to select the software installation package that corresponds to your computer
system. The same process applies to importing configurations for Bambu Handy.
3.2 Configuration import
a. Open the software, enter the interface of selecting the printer, select "Generic KlipperPrinter", and then confirm to complete.
b. Select File → Import → Import Presets. Process configuration, consumables configuration and machine configuration can be
imported respectively. Then start your slice printing. After slicing is complete, please copy the file to the USB flash drive,
and then insert it into the USB port of the machine for printing.
27
13.4 Web upload files for printing
After the machine is connected to WiFi on the screen, it remembers its IP information. Then open the browser on the
computer side and enter the IP address of the machine to enter the Klipper control interface for corresponding
operations. Select "File" in the left taskbar of the Klipper control interface, upload the file and print it. It should be
noted that the IP address may change after the machine is powered off and turned on again,
so check the IP address again after each restart.
System Network Calibrate
IP:119.123.78.150
EN
IP address
28