two trees SK1 Bedienungsanleitung Seite 15

1.3 Configuration import.
The file provides 6 kinds of height parameters, of which 0.2 height contains standard parameters and fine parameters.
You can select the appropriate parameters to import according to your needs, and then start slicing printing. After slicing
is complete, please copy the file to the USB flash drive, and then insert it into the USB port of the machine for printing.
13.2 Import Prusa software configuration
2.1 Find the Prusa software package in the USB flash drive (also available on the official website) and install it.
Please select the software installation package corresponding to your computer system.
25
2.2 In the USB flash drive data, find the folder "Prusa config", which contains the sliced Cura-End G-code and Cura-Start
G-code. After opening the Prusa software, go to printer Settings, then select Custom G-code and change the start
G-code and end G-code to the corresponding code.
2.3 Configuration import
The file provides 6 kinds of height parameters, of which 0.2 height contains standard parameters and fine parameters.
You can select the appropriate parameters to import according to your needs, and then start slicing printing. After slicing is
complete, please copy the file to the USB flash drive, and then insert it into the USB port of the machine for printing.
EN
26