Emos E5062 Bedienungsanleitung Seite 7

Getting Started
1. Connect the power adapter to the weather station, then insert batteries (3× 1.5 V AAA) into the station.
Remove the battery compartment cover on the back of the sensor, use the channel selector to set the
sensor number (1/2/3) and insert alkaline batteries (2× 1.5 V AAA). Make sure the polarity is correct when
inserting the batteries to avoid damaging the weather station or sensor.
2. The icon for wireless communication with sensor will start flashing, indicating that the weather station
is searching for signal from the outdoor sensor. Place the two units next to each other. If outdoor tem-
perature does not appear within 3 minutes, the weather station will stop searching for signal, the icon
for wireless communication with sensor will stop flashing and outdoor temperature will be displayed as
--.-. If signal from the sensor is not detected, repeat the process from step 1.
We recommend placing the sensor on the north side of the house. The range of the sensor may decrease
substantially in areas with a large number of obstacles. The sensor is resistant to dripping water; however,
it should not be exposed to sustained rain.
Do not place the sensor on metal objects as these would reduce transmission range.
The sensor can be placed vertically or hung on a wall.
If the weather station screen shows the low battery icon
sensor.
The low battery icon displays for each sensor separately.
If the weather station screen shows the low battery icon
Weather Station RESET
If the weather station displays incorrect values or does not respond to button presses, disconnect the power
adapter, remove the batteries, then reinsert the batteries and reconnect the adapter. This will erase all data;
you will need to set the weather station again.
A sensor can be restarted by pressing the RESET button (use a paper clip or similar).
Changing Sensor Channel and Connecting Additional Sensors
The station can be paired with up to 3 wireless sensors.
1. Press the CH button repeatedly to select sensor number 1/2/3.
2. Long-press the CH button; the station will start searching for signal from sensors; a
flashing for all of them.
3. Remove the cover from the battery compartment on the back of each sensor,set the sensor channel
number using the selector (1, 2, 3 – each sensor must be set to a different number), then insert alkaline
batteries (2× 1.5 V AAA).
4. Data from the sensors will be loaded into the station within 3 minutes. Repeat the whole process if sensor
signal is not detected.
Manual Settings
1. Long-press the MODE button; settings will start flashing.
2. Use the UP/DOWN buttons to set values for: year – month – day – 12/24 h time format – hour – minute.
3. Short-pressing MODE navigates between the values.
4. Press and hold the UP/DOWN buttons to set the values faster.
Note: The station will load the current time/date automatically after connecting to a Wi-Fi network. The
icon will be displayed.
in field no. 14 , replace the batteries in the
in field no. 4, replace the batteries in the station.
GB | 5
icon will be