Werbung
Verfügbare Sprachen
Verfügbare Sprachen
PROBLEM
CAUSE
◾
◾
◾
The mower unexpectedly
◾
stops while mowing.
◾
◾
◾
◾
◾
There is excessive
◾
vibration.
◾
◾
◾
The motor works but the
blade set doesn't cut the
grass.
◾
Difficulty moving the clip
selector knob from side
to side.
WARRANTY
EGO WARRANTY POLICY
Please visit the website egopowerplus.eu for full terms and conditions of the EGO Warranty policy.
The battery pack charge is depleted.
Mower is overloaded and the mower status
indicator flashes orange.
Mower deck is clogged with grass and
debris.
The battery pack or mower circuitry is
too hot. If the battery pack is overheated
the mower status indicator goes off. If the
mower is overheated the mower status
indicator glow solid orange.
The blade speed mode is not set properly.
The mower electronics error and the mower
status indicator flashes red/green alternately.
The cutting blade set is loose.
The cutting blade set is unbalanced.
The cutting blade is bent.
The motor shaft is bent.
The mower is set to cut too much grass at
once.
The blade speed mode is not set properly.
The blade set is not tightened to the required
torque.
Excessive grass clippings have accumulated
on top of the sliding.
56 VOLT LITHIUM-ION CORDLESS MOWER — LM2230E-SP
SOLUTION
◾
Charge the battery pack.
◾
Check if grass has accumulated
beneath the deck and clean if
needed. Raise the cutting height
or slow down the mowing.
◾
Unclog the mower deck. Raise
the cutting height and/or cut a
narrower swath.
◾
Allow the battery pack or mower
to cool down.
◾
Select the blade speed to a
lower setting.
◾
Contact EGO Service Center.
◾
Tighten the blade bolt.
◾
Contact EGO Service Center.
◾
Replace the blade.
◾
Contact EGO Service Center.
◾
Raise the deck to a higher
cutting-height setting.
◾
Set the blade speed to a lower
setting.
◾
Re-tighten the blade set. The
recommended torque for the
blade bolt is 50-60 Nm.
◾
Clear grass from the mower
deck after each use door.
EN
17
Werbung
