Werbung
2.Front guard and mudguard assembly
Attach the front guard
to its correct position on the car body, then fasten it using a
M4*14 screw
. Apply the sticker
onto the front guard
, as shown in the picture.
Insert the mudguard
into the correct position on the car body, then from the bottom,
secure it with four M4*14 screws
using a screwdriver.
Screwdriver
(Not Included)
3.Front wheel assembly
Using the wrench
, remove the front axle (A). You will not need the front axle (A) for
the next assembly steps.
Loosen the two nuts (C) from the front wheel
using the open spanner
, then
remove the two washers (B).
5
Werbung
