Silvercrest SWKK 100 A1 Bedienungs- Und Sicherheitshinweise Seite 25

Note: The function display
the heating pad is switched on.
Note: This heating pad features rapid heating,
which allows it to heat up within the first 10 mi-
nutes of operation.
Switching off:
Set the control unit
heating pad.
Note: The operating display
Selecting the temperature:
Just before using the heating pad, set it to the
highest temperature setting (setting 6). This will
cause the heating pad to warm up quickly.
When using the heating pad for several hours, set
it to the lowest temperature setting (setting 1).
When operating the heating pad
for several hours, we commend setting the control
unit to the lowest setting to prevent overheating
1
and potential burns to the part of the body heat is
applied to.
Temperature levels
Set the required temperature level on the con-
trol unit (see fig. A).
1
Level 1: 42° C ± 12 %
Level 2: 46° C ± 12 %
Level 3: 53° C ± 12 %
Level 4: 58° C ± 12 %
Level 5: 64° C ± 12 %
Level 6: 71° C ± 12 %
The temperatures were determined according to
the EN-60335-2-17 test standard.
Automatic switch-off
Note: The heating pad switches itself off automati-
cally after about 90 minutes. The function display
then starts to flash.
07.101.223_SWKK100A1_2023-04-13_01_IM_Lidl_LB8_OS_content.indd 23 07.101.223_SWKK100A1_2023-04-13_01_IM_Lidl_LB8_OS_content.indd 23
illuminates after
2
to 0 to switch off the
1
will switch off.
2
2
Then select the setting 0 and after about 5 se-
conds, reset the heating pad to the desired
temperature setting to switch it on again.
If the heating pad is no longer used after
the timer expires:
– switch off the heating pad (setting 0),
– unplug from the socket,
– disconnect the plug-in connection
control unit , from the heating pad.
1
Cleaning and care
LIFE BY ELECTRIC SHOCK! Always
remove the mains plug from the socket
and the plug-in connector
unit from the heating pad (see fig. B) before
1
cleaning the heating pad. Otherwise there is a
risk of electric shock.
Use a dry, lint-free cloth for control unit
ning and care.
RISK OF DAMAGE TO THE PRO-
DUCT OR PROPERTY! Never im-
merse the control unit
other liquids. It may otherwise be damaged.
If the heating pad is slightly soiled, use a dam-
pened cloth and a little liquid mild detergent, if
necessary.
RISK OF DAMAGE TO THE
PRODUCT OR PROPERTY! Do
not use chemical cleaning or scour-
ing agents to clean the heating pad or control
unit . This could damage the heating pad
1
and control unit .
1
Always remove the inner cushion
cleaning. To do this, open the zip fastening
The inner cushion
be washed.
The cover with built-in heating pad
is machine washable. Set the
3
washing machine at an extra gentle
washing cycle at 30 °C.
For ecological reasons, only wash the cover
with built-in heating pad
textiles. Use a mild laundry detergent accord-
ing to the manufacturer's instructions.
, i.e. the
6
DANGER TO
with the control
6
clea-
1
in water or
1
before
5
.
4
cannot
5
along with other
3
GB/IE 23
05.07.23 10:43 05.07.23 10:43