Silvercrest SWKK 100 A1 Bedienungs- Und Sicherheitshinweise Seite 24

pad or similar items on it. The
heating pad may otherwise be
damaged.
The electronic components inside
the control unit will heat up whilst
operating the heating pad. For
this reason, the control unit must
not be covered or be lying on the
heating pad during operation.
This poses a risk of injuries and/
or damage to the heating pad.
Always observe the information
on start-up, cleaning and care,
and storage.
RISK OF DAMAGE TO
THE PRODUCT OR
PROPERTY! Let the heating pad
cool before putting it away. This
could damage the heating pad.
RISK OF DAMAGE TO
THE PRODUCT OR
PROPERTY! To prevent the heat-
ing pad from becoming sharply
creased, do not store other objects
on top of the heating pad. These
may all damage the heating pad.
If you have additional questions
on using our products, please
contact our Customer Service
Department.
22 GB/IE
07.101.223_SWKK100A1_2023-04-13_01_IM_Lidl_LB8_OS_content.indd 22 07.101.223_SWKK100A1_2023-04-13_01_IM_Lidl_LB8_OS_content.indd 22
Safety system
Note: The heating pad is equipped with a safety
system. The electronic sensor technology prevents the
entire surface of the heating pad from overheating
by automatically switching off in the event of a fault.
If the safety system switches the heating pad off au-
tomatically due to a fault, then the function display
on the control unit is no longer illuminated, even
1
if the heating pad is switched on.
Please note that, for safety reasons, the heating
pad must not be used after a fault and must be
returned to the service address indicated.
Under no circumstances should you connect the
defective heating pad to another switch of the
same type. This would also result in a permanent
shutdown by the safety system in the switch.
Special features
This heating pad has been pro-
vided with an especially soft
and hygienic velour fabric. The
textiles used in this heating pad meet the strict
human ecological requirements of Oeko-Tex
Standard 100, as verified by the German
Hohenstein Research Institute.
Start-up
Note: The heating pad may smell of plastic the first
time you use it, but this will disappear after a short
period of time.
To begin, first connect the control unit
heating pad with the plug-in connector
(see fig. B).
Then insert the mains plug into the socket.
Switching on/off/Selecting the
temperature
Switching on:
Set the control unit
1
switch on the heating pad.
2
to the
1
6
to 1, 2, 3, 4, 5 or 6 to
05.07.23 10:43 05.07.23 10:43