Installation; Installation Site; Wall Mounting; Power Supply - STIEBEL ELTRON ISG Web Bedienung Und Installation

INSTALLATION

Installation
INSTALLATION
6. Installation
6.1

Installation site

The ISG is designed for wall mounting and is installed between
your router and your heat pump/integral ventilation unit.
Note
The ISG connects to the interface for the second pro-
gramming unit.
f Observe the operating and installation instructions f
of your heat pump or integral ventilation unit.
Material losses
!
The installation site must be dry and protected against
frost.
f Observe the application limits in the chapter "Spec- f
ification".
6.2

Wall mounting

f Mount the ISG on a suitable wall: f
22 | ISG web
f Push the ISG to the right, until you feel it latch into the f
retainer.
6.3

Power supply

Note
The ISG connects to the interface for the second pro-
gramming unit or the remote control of your heat pump/
integral ventilation unit.
If there is only one interface, the ISG connects in parallel
to the CAN BUS as an additional programming unit.
f Use the CAN BUS cable supplied to connect the ISG to your f
heat pump/integral ventilation unit via the CAN interface.
When doing so, observe the operating and installation in-
structions of your heat pump/integral ventilation unit.
www.stiebel-eltron.com