Werbung
Verfügbare Sprachen
Verfügbare Sprachen
8. When in standby, press and hold the power button for five seconds – the appliance will
enter self-cleaning mode – the 'clean' indicator will turn red.
After 15 minutes, the appliance switches to standby mode – the power indicator flashes.
Tips:
When the ice box is full, the 'ice full' indicator on the display panel will light up (red) –
the machine will stop automatically. When the ice is removed, the machine will start
working.
If water is insufficient, the 'add water' indicator lights up (red) and the machine will
stop working. After refilling, press the power button to restart.
When not in use, turn off and unplug the machine.
Ice storage capacity
* When the ice basket is full, the machine will stop automatically and enter standby.
* The ice maker can partially block heat and store ice temporarily, however it cannot
be used as a freezer.
* Please remove ice cubes and add water to ensure machine works properly.
Sound during machine operation
The new ice maker may make unfamiliar sounds. Most sounds are normal, for
example:
* Compressor emits beating or sharp sounds.
* Water splashes from the evaporator to the tank.
* At the end of each cycle, you can hear the gurgling of the refrigerant flowing.
* The sound of air compressed by the fan over the condenser.
* In the final deicing cycle, you may hear ice falling into the box.
Cleaning and Maintenance
Regular cleaning and correct maintenance will keep your machine in top working
condition.
* Before cleaning, turn off and unplug the machine.
* Do not use solvent-based cleaning agents, which may damage the machine.
* Do not wash the machine. Wipe the outside of the machine with a damp cloth.
* Dry the inside and outside of the machine with a soft and clean cloth.
* Regularly check the drain plug, ensuring it is tight to prevent leakages.
* After the first use or if it has not been used for long periods, clean the machine.
* Disinfection solution: water and vinegar or citric acid (ratio: 10:1)
* Wipe the inside with a neutral cleaning agent, including the evaporator (icing
column).
* Add ice making water, run the machine and discard the ice cubes produced in the
first four cycles, then remove the remaining water from the drain and reinstall the
plug, ensuring it is properly in place.
* Use a clean, soft cloth to remove any remaining watermarks.
Strange smell
If the ice has a strange taste or odour, follow the above steps to clean the inside of the
machine.
4
Werbung
