Fronius RC PM 10 Bedienungsanleitung Seite 6

Operation
Safety
Connecting the
remote control
Using the keylock
switch
6
WARNING! The plasma power source PM 10 can be controlled using either the
control panel on the power source PM 10 or using the remote control RC PM 10.
This creates the risk that the power source PM 10 may be activated unexpectedly
(plasma process startup, etc.), which may cause serious injury and damage to
property.
To ensure safe operation, always ensure that the power source PM 10 is secured
against unexpected activation. This can be done by locking the remote control RC
PM 10 using the keylock switch, for example.
(1)
Connect the remote control cable to
1
the LocalNet connection socket (1) on
the back of the plasma power source
NOTE! When the keylock switch
is in a horizontal position (1), all
keys on the control panel are
locked
- If a key is pressed when the
control panel is locked, the
message "Clo|SEd" will ap-
pear briefly on the display
- Using the adjustment wheel,
the parameter that was se-
lected when the keys were
locked can also be changed
(1)
while the keylock is active