Creality Falcon2 Benutzerhandbuch Seite 4

During the laser engraving, please wear goggles to avoid vision damage caused
•
by looking directly at the laser spot.
Smoke or smells may be produced during laser engraving and cutting. It is
•
recommended to operate in a well-ventilated environment.
Children under the age of 10 are strictly prohibited from using this product
•
without adult supervision to avoid injury.
Prepare fire extinguishers as a backup. Regularly maintain and inspect the fire
•
extinguishers.
It is forbidden to leave it unattended while the machine is working.
•
Users should abide by the laws and regulations of the corresponding country and
•
region where the equipment is located (where it is used), practice professional
ethics, and pay attention to safety obligations. It is strictly forbidden to use our
products or equipment for any illegal purposes. If there is any violation, we will
not be responsible for the relevant legal responsibilities.
Firmware Update
Download the latest firmware from
firmware/other?type=16, back up and delete the files on the TF card and save the bin file
to the root directory of the TF card.
Motherboard Update
When the machine is powered off, insert the TF card into the card slot, and it will
automatically update the firmware when it is powered on. The buzzer will keep beeping
during the update process, and the update will be completed when the beep ends
(please keep the power on until completed).
Laser Module Firmware
When the machine is powered off, insert the TF card into the card reader, then insert it
into the USB-C port on the top of the laser module through the USB-A to USB-C adapter,
and the firmware will automatically update when it is powered on. During the update
process, the indicator of the laser module will turn orange with a marquee effect, and
the update will be completed when it stops the marquee effect (please keep the power
on until completed).
https://www.crealitycloud.cn/en/software-
4