Creality Falcon2 Benutzerhandbuch Seite 12

LENS: Detects whether the lens of the laser module is dirty.
•
o Red: The lens is seriously dirty. Please stop the current work immediately, and
clean and maintain the laser module.
o Orange: The lens is slightly dirty. It is recommended to stop the current work
as soon as possible, and clean and maintain the laser module.
o Green: The lens is not dirty. Please clean and maintain the laser module
regularly.
Notes:
The alarm functions of the laser module can be enabled or disabled, but the
•
indicator light will still indicate the current situation normally when disabled. To
enable the alarm, please refer to the "Laser Module Alarm Function.pdf" in the
included documents.
When receiving an alarm, please check the laser module carefully, and then press
•
the Reset button on the laser module to stop the alarm.
The USB-C port on the laser module can be used to upgrade the firmware of the
•
laser module or export the work log of the laser module. When the port is not in
use, please plug in the dust-proof plug.
Unlike the 12W and 22W laser modules, the laser beam of the 40W laser module
•
can be adjusted by holding on the "Reset Button" for 2 seconds after power on.
The indicator lights can indicate the current mode:
o Two lights on (Normal): The maximum output power is 40W. It can cut
thicker material and cut faster.
o One light on (Precise): The maximum output power is 20W. It can engrave
more precisely and leave a narrower kerf.
o Please refer to "Description of GRBL configuration parameters.pdf " in the
TF card for more information.
12