Creality Falcon2 Benutzerhandbuch Seite 11

Indicators
Control Panel
The indicator is off: The machine is in a power-off state.
•
Solid white: The machine is in the initialization mode, and it will automatically enter
•
the standby mode after the initialization is completed.
Flashing purple: The machine is in the firmware upgrade mode, and the buzzer
•
makes a rapid sound at the same time. It will automatically enter the standby mode
after the upgrade is completed.
Flashing red: The machine is in abnormal mode, and the buzzer makes a rapid
•
sound at the same time. It will automatically enter standby mode after dealing with
the abnormality.
Pulsing green (slowly): The machine is in standby mode, and you can press Frame
•
button to enter preview mode.
Solid blue: The machine is in preview mode or engraving mode, and the laser
•
module is emitting a beam. Special attention should be paid to safety.
Flashing yellow: There is no gcode file in the root directory of the TF card, and the
•
buzzer will sound two beeps.
Laser Module
AIR: Detects the current airflow passing through the laser module.
•
o Flashing red: No airflow. Smoke and dust may contaminate the lens during
engraving or cutting, please check the working status of the air pump and
ensure that the silicone tube is connected.
o Solid orange: Small airflow volume. It is recommended to enable a small
airflow volume when engraving, since a large airflow volume can affect the
engraving result.
o Solid green: Large airflow volume. The airflow volume can be adjusted
according to individual needs when cutting.
FIRE: Detects whether the processed material is burning.
•
o Red: Flame is detected. It is recommended to stop the current work
immediately to ensure safety.
o Orange: There is a fire hazard. Please confirm the material and set the
working parameters properly.
o Green: No flame is detected. Please clean and maintain the laser module
regularly.
11