Creality Falcon2 Benutzerhandbuch Seite 3

Dear customer,
Thank you for purchasing our product. Please read the following instructions carefully
before first use and keep this user manual for future reference. Pay particular attention
to the safety instructions. If you have any questions or comments about the device,
please visit our customer support page: www.alza.cz/EN/kontakt.
Importer Alza.cz a.s., Jankovcova 1522/53, Holešovice, 170 00 Praha 7, www.alza.cz
Security Statement
When a laser engraver engraves or cuts materials, it casts a high-density laser beam that
heats the surface to vaporize materials without burning them. But most materials are
inherently flammable and can be ignited, which may burn the machine and the
surroundings.
Caution – Use of controls or adjustments or performance of procedures other than
those specified herein may result in hazardous radiation exposure. The laser safety
classification of this product is based on IEC 60825-1:2014. The laser safety level of laser
radiation emitted through laser aperture exceeds Class 1.
Please use it as instructed below:
Do not place this product near flammable and explosive materials, volatile
•
solvents or heat sources. Please place this product in a ventilated, cool and dust-
free environment.
Do not use power cords other than the one provided in the package during the
•
installation.
Regularly clean the body and laser module with an anti-static brush and a dry
•
cloth when the machine is powered off.
Please connect the silicone tube on the laser module whether using an air assist
•
or not. This will reduce the risk of lens contamination.
The working temperature of the laser module is 5°C-35°C. Avoid using this
•
product in a humid environment, and do not use it during a thunderstorm.
If the product isn't used for a long time, please turn off the product and
•
disconnect the power cord.
When the product is connected to the power supply, please do not touch the
•
electronic areas with your hands or other tools. DO NOT plug and unplug the
laser module cable when the machine is powered on.
When the product is running, please do not touch any part of the moving system
•
or laser module.
Please place a flat object that the laser cannot penetrate under the processed
•
material, such as aluminium alloy.
3