Creality Falcon2 Benutzerhandbuch Seite 10

Software Installation and Use
The machine can be controlled with LaserGRBL or LightBurn after being connected to a
PC via a USB-C cable and can also work by reading codes (exported from Lightburn) on a
TF card. For software tutorials, please refer to the information provided on the TF card.
Control from PC
Connect the machine to a PC via a USB-C cable. If your computer does not have a USB-A
port, please use the included adapter to convert it. While controlling from PC, you can
also control it through the Start/Pause button on the control panel of the machine.
Memory Card
Generate the engraving file (gcode) through the LightBurn software and save the file to
the root directory of the TF card (the machine will access the file with the latest data in
the root directory of the TF card by default, so it is advised to delete other irrelevant files
in the first directory). Insert the TF card into the machine before powering it on, plug in
the power adapter and power cord, and turn on the power button.
After the machine is powered on, it will sound two beeps and enter standby mode. The
indicator light will pulse green slowly.
Press the Frame button, and the machine will exit the standby mode and enter the
preview mode. The laser module will emit a weak beam and move along the X/Y axis to
frame the target working area. The indicator will be in solid blue. You can adjust the
material to a suitable position or make fine adjustments through the arrow buttons on
the control panel.
In the preview mode, press the Start/Pause button to enter the engraving mode, the
laser module will emit a strong beam, and the machine will start engraving. The
indicator will be in solid blue. If you need to pause the engraving, please press the
Start/Pause button, and the indicator light will pulse green slowly. Press the Start/Pause
button again to continue engraving.
If you need to cancel the engraving, please press and hold the Start/Pause button for 3
seconds, the machine will sound a beep, and the machine will reset. After the reset is
completed, the machine will sound two beeps and enter the standby mode. The
indicator will pulse green slowly.
After the engraving is completed, the machine will sound three beeps and then reset.
After the reset is completed, the machine will sound a beep and enter the standby
mode, and the indicator will pulse green slowly.
10