FLINQ Smart Outdoor Christmas Tree Luminus Handbuch Seite 6

Manuel
EN
Install your Luminus Tree with stand 1/2
assemble stand
1
Assemble the base by inserting the poles
into the base as shown in the picture
above.
Connect other pole sections
5
Connect the other two pole sections to
the upper part of the tree light stand.
Connect the light strings
2
Connect the light string to the upper part
of the tree light stand.
L R
Left and right labels: Each light chain
has 2 thicker outer ropes which at
the end are marked with an LEFT and
RIGHT label thread and inner ropes.
Note: The outside diameter of the assembled Tree with light chain is approx Ø125
cm max
Hang hook on the bracket
3
After the light string is connected, hang
the hook on the bracket as shown in the
picture above
Lower the wires in the bags
6
1 Person is holding the pole and then
open the 5 bags carefully by the 2nd
person and let the string lights face 1MT
down 1 by 1.
FlinQ Smart Outdoor Christmas Tree Luminus
Connect the adapter
4
Connect the adapter to the upper part of
the tree light stand.
Attach pole to stand
7
Attach the pole to the ground stand.