FLINQ Smart Outdoor Christmas Tree Luminus Handbuch Seite 4

Manuel
EN
Install your Luminus Tree with groundpin 1/2
Place groundpin
1
Place the ground pin in the ground. Make
sure that the ground pin is at a 90 degree
angle (as shown in the picture above)
before pressing it into the ground.
Connect the adapter
5
Connect the adapter to the upper part of
the tree light stand.
Place the ground pegs
2
Use the included measuring belt to
measure from the ground spear (add it
around the top screw part of the pole)
and straight out in 5 points around the
ground spear. Place a ground peg to
mark the spot.
Connect other pole sections
6
Connect the other two pole sections to
the upper part of the tree light stand.
Note: The outside diameter of the assembled Tree with light chain is approx Ø125
cm max
Connect the light strings
3
Connect the light string to the upper part
of the tree light stand.
L R
Left and right labels: Each light chain
has 2 thicker outer ropes which at
the end are marked with an LEFT and
RIGHT label thread and inner ropes.
FlinQ Smart Outdoor Christmas Tree Luminus
Hang hook on the bracket
4
After the light string is connected, hang
the hook on the bracket as shown in the
picture above
Lower the wires in the bags
7
1 Person is holding the pole and then
open the 5 bags carefully by the 2nd
person and let the string lights face 1MT
down 1 by 1.