Battery Replacement Method (3V Batteries For Date And Time Output) - Witeg Wisd Wac-R Bedienungsanleitung

complete the installation of the paper.
 If the end of the paper is hanging to a roller, or the margin needs back and forth of the
outputs, the user can take the paper out a little bit by pressing the "FEED" button.

7.2 Battery Replacement Method (3V batteries for Date and Time Output)

 When the power is turned ON, need to replace the battery when the Date and Time
stored disappear and initializes. (initialization state: DATE : 2000/00/00 , TIME :
00:00:00)

Shut off the power
distribution board panel as shown in the figure.
 After panel removal Check the Main Controller Board located in the power distribution
board.
 After checking the with 3V battery of Main Controller Board, put a tweezers to gap and
remove the battery.
 Replace a new battery and turn ON the power of product and then reset the Date and
Time
 The battery replacement period is usually two years, please be sure to use the same
specification of shipped factory battery.
 May be shortened replacement cycles depending on the initial condition and
environment of the battery.
28
of the product and open the Door on the Left Side. Remove the
witeg Labortechnik GmbH, WAC-R Steam Sterilizer
www.witeg.de