Scan Settings; Audio Settings; Bluetooth Operation - Scansonic In220 Benutzerhandbuch

Other Settings

• Scan settings

FM scan is defaulted to stop at any available station, this would result the poor reception
from weak stations. To change the scan settings to stop only at stations with good signal
strength, press the MENU button then enter into the "Scan setting" section and select YES
by the use of the SELECT control.

• Audio settings

The radio will automatically switch between FM stereo and mono reception, but you can
override this and switch this function manually which is helpful for poor signal reception.
To select listening in mono, press the MENU button then enter into the "Audio setting" section
and select YES by the use of the SELECT control.
Note: During FM stereo reception, the received L/R stereo sound will be automatically
combined to one single channel to suit the single speaker design of this radio.
Bluetooth operation
®
The unit has a Bluetooth function that can receive a signal within 8 metres. Pairing the unit
with a Bluetooth device to listen to music:
1. Press the MODE button repeatedly on the unit to select BLUETOOTH.
2. Activate your Bluetooth device and select the search mode.
3. "Scansonic IN220" will appear on your Bluetooth device list.
4. Select "Scansonic IN220" and enter "0000" for the password if necessary.
5. To disconnect the Bluetooth function, switch to another function on the unit or disable
the function from your Bluetooth device.
Note:
• The operational range between the unit and the device is approximately 8 metres.
• If the signal strength is weak, your Bluetooth receiver may disconnect, but it will re-enter
pairing mode automatically.
• For better signal reception, remove any obstacles between the unit and the Bluetooth
device.
• Compatibility with all devices and media types is not guaranteed.
• Some mobile phones with the Bluetooth function may connect and disconnect as you
make and end calls. This is not an indication of a problem with your unit.
AUX in
AUX in mode plays audio from an external audio source such
as MP3 player. To play audio with Aux in mode:
1. Decrease the volume level on both the radio and the audio
source device.
2. Connect the external audio source to the AUX IN (3.5mm)
stereo socket.
3. Either press MODE until the display shows "AUX in" or select "AUX in" in the main menu
by the use of the SELECT control.
4. Set the desired volume on the radio and the external audio device if necessary.
Note: To further enhance energy saving, unit will go into standby mode after about 15 minutes
from Aux in mode if without signal input.
14
IN220
INTERNET /DAB+/
FM RADIO WITH BT
IIaal Save to Preset
1. 107.50MHz
2. [Not set]
3. [Not set]
4. [Not set]
5. [Not set]
17:20
Auxiliary Input
Audio In
Today's Date:
03/04/2010