DTM System FLEX4G Betriebsanleitung Seite 22

Adding a remote control with the Galactic function
The condition for success is that the authentication code in the added remote control and the receiver match.
To add a remote control with the Galactic function, you must be within the radio range of the receiver:
- press and hold any two remote control buttons for 5 seconds
- activate the remote in the system by pressing any button
The assigned remote control works immediately in accordance with the settings programmed in the remote
control.
5s
1
Fig.4 Adding a remote control with the Galactic function.
4.4. Factory settings. Formatting the receiver
Formatting the receiver restores the receiver to the factory settings and deletes all remote controls,
all subscribers from the receiver's list and the event memory.
To format the receiver, press and hold the SW button for 10 seconds. Release the button when the "running
line" effect begins (indication on the RTC, AUT, CON, ERR diodes).
Receiver factory settings:
- all receiver channels set to monostable mode with a switch-on time of 0.5 s,
- all NO inputs,
- default receiver name, output channels and inputs,
- disabled SMS confirmations presenting the status of inputs.
4.5. APN Settings
The receiver automatically downloads the APN settings of the operator it is connecting to. In rare cases, it may
be necessary to change the settings manually. The APN settings can be modified and read using SMS.
Note! The receiver accepts SMS commands only after pressing the SW button on the receiver board (the ERR
diode lights up then).
Automatic APN setting (default): setapn=auto
Manual APN setting: setapn="name","user","pass" (if the parameter does not exist, enter empty characters
"")
Reading the current APN setting: getapn
2